Protection for crushers, grinders and other machines
Metal detector PSQ RA
- Extremly resistant to weather, dirt or impact of stones and also immune to vibration
- Simple and timesaving mounting: belt must not be devided due to a devidable probe
- Can be used in the proximitry of frequency converters
- Low difference in sensitivity on different sensing heights above the belt
The PSQ RA series of metal detector (opterating with a frame-probe) detects all kinds of metal, which means not only iron, but also aluminium, stainless steel, copper or mild steel.
The specialty of this detector is a low difference between edge and center of probe aperture. Therefore it is especially suitable if the depth of burden on the belt is more tan 600 mm. It’s frame can be devided and easily be built around the belt.
This metal detector prevents damage, avoids downtimes and produces significant savings on repair costs.
digital signal processor, noise filter, digital balance control, digital frequency control, PowerDrive circuit
1 coaxial cable, probe
Metal alarm: 1 relais with 2 floating changeover contacts, switching capacity 230 V 5 A resistive load, switchable between normally relaxed or normally activated mode
Fault signal: 1 relais with 2 floating changeover contacts, switching capacity 230 V, 5 A resistive mode
Iron, non-ferrous (e.g. aluminium or copper) und stainless steel
1000 – 2400 mm
Control box: IP 55
Frame probe: IP76
Control box: -20° C up to +55° C
Frame probe: for execution PE up to +60° C, for execution PA6.6 up to +120° C
110-230 V, 50/60 Hz, typ. comsumption 15 VA
Control box: steel or stainless steel, grey RAL 7032, electrophoretic dipcoating
Frame probe: stainless u-structure steel
Support for mounting: PE or PA6.66
Further information for download:
Information about the sensitivities can be found in the data sheet which is available here for download as PDF.